English   |   Español

Robust Molding Processes - The Five Pillars and The Three Consistencies

It is relatively simple to injection mold a plastic part. It is simply a ‘Melt – Inject – Cool’ process. Once the user figures out the machine controls and its settings it is almost as simple as ‘Play dough in a kids hand’. It is this very reason that most companies struggle with molding parts consistently and eventually some companies go out of business for lack of efficiency. The process settings on a molding machine consist of various speeds, pressures, times and temperatures. Each of these must be optimized in such a way that the molded parts are consistent in quality. Quality consistency is only achieved when the process is consistent which means that the process must be robust and not sensitive to natural common cause variations. Robust processes produce parts that have a consistent and predictable quality. The following are the main advantage of a robust process

The Five Pillars

A molding process can only be robust provided the following five pillars are considered:

  1. Part Design
    • Design should lend itself for injection molding
    • Design should follow Plastic Part Design principles
  2. Plastic
    • Should be selected to match required quality and tolerances
    • Should be possible to process with given equipment
  3. Mold Design and Construction
    • Design should provide optimum gate location, runner design, venting and cooling
    • Construction should be robust providing a wide Cosmetic and Dimensional Process Window
  4. Molding Machine
    • The % shot size used should be ideally between 20% and 80% of the machine shot size
    • The residence time in the barrel should be less than the maximum recommended residence time for the material
  5. Molding Process
    • Should be robust and optimized
    • Should be repeatable and reproducible  

The Three Consistencies

There are three types of consistencies that need to be achieved in Injection Molding.  These are as follows:

1. Cavity to Cavity Consistency

In multicavity molds, every cavity must produce identical quality parts.

Reasons why this may not be achieved:

2. Shot to Shot Consistency

The parts molded during every consecutive shots are identical in quality.

Reasons why this may not be achieved:

3. Run to run consistency

Reasons why this may not be achieved:

© 2017 Fimmtech Inc. All rights reserved. Terms of use.
Back to top